Method of Application
DPC DampBlock is usually applied by using a propane torch or a hot air generator as well as by mechanical fastening. It can also be applied using special adhesives in cold or hot applications. The substrate surface must be clean, dry, smooth, and free from any irregularities. According to the surface conditions, a coat of TECHNOBIT PRIMER maybe required prior to the application of the membrane.
DPC DampBlock can be applied to the substrate fully bonded, semi bonded or loose laid, and the method of adhesion to the substrate shall be decided according to the waterproofing system design. Side laps should be from 8 – 10 cm, while end laps should be from 12 – 15 cm. For more information on application refer to TECHNOBIT application guide.
Close Every Gap. Restore Every Surface.
