Technobit Cold Applied Joint Sealant

The surfaces should be dry and properly cleaned of loose particles, grease and oil.

TECHNOBIT COLD APPLIED JOINT SEALANT should be thoroughly stirred before use . to ensure an homogenous consistency.

Work is carried out at a temperature between 20 – 45 °C.

In cold climates, TECHNOBIT COLD APPLIED JOINT SEALANT should be heated 45 – 60 in water bath (not direct flame ) to obtain a smooth plastic consistency, on hot days, work is done in the morning before noon with the need to prime the surface.

If the surfaces of the joints to be sealed are non-porous, or slightly porous TECHNOBIT COLD APPLIED JOINT SEALANT can be applied directly on them where as it recommended on prime porous surfaces using TECHNOBIT PRIMER WB TS3 or TECHNOBIT OXIDIZED BITUPAINT PF4 or TECHNOBIT PRIMER WB TS3 R.

Cover the edges of the surfaces of the joints with a proper adhesive tape.

Apply TECHNOBIT COLD APPLIED JOINT SEALANT mechanically or manually according to the type of the job.